Pop Out Gatefold Wedding Card.

The inspiration for this card came from a tutorial in Junes Papercraft Inspirations magazine.  I have used First Editions Wanderlust papers and All Occasion Romantic Couple die.

Cut card the height of your largest chosen nesting die by 27cm.  Score at 8.5, 11, 16 &18.5cm.  Burnish & fold  valley, mountain, mountain, valley on all score lines. Slide the die onto the card with the cutting edge up, see photo 2.  Turn over, line up the die with the centre,  hold in place with low tack tape then die cut, see photo 3.  That will give the basic shape for you to decorate.  Any large die will work well for this shape as long as you measure the die to know what height to cut the card.






Comments

Post a Comment

Popular posts from this blog

Double Impossible Card

Image
A variation on the popular impossible card shape.  For this card I used Dovecraft's Lost & Found collection of papers, dies, stamps and great embellishments.  The second photo is a template to go with the measurements. Here's how I made it. Cut cream card 17.5 x 14cm.   In light pencil mark across the half way point at 7cm.   See 2nd photo for template. In the top section mark at 5.9 and 11.8cm and draw to the centre line.   The bottom section mark at 2.5, 6.8, 11 and 15.2 cm to the centre line.   Cut the top and bottom section lines. Rub out pencil.   Score the blue lines. Twist the   2 outside sections away from you and burnish the score lines.   Decorate with patterned papers, I drew round the card then cut the papers slightly smaller.   Back 2 wooden hexagons with patterned papers then stick to some cream card hexagons.  Paper piece the hexagon scene die with different coloured card,  stamp bear onto patterned paper and cut out.  Stick to card fronts. Add washi tape
Read more
Image
Have been admiring the tower cards posted  recently and thought I would give it a try.  After some failed knife cutting attempts I decided to try it with less cutting lines and make the side panels wider. Thank you to the Crafty Blonde for the initial inspiration.  Here's how I made mine. Cut black card 5x10 inches and score at 1.5, 2.5, 3.5, 6.5, 7.5, 8.5 inches.   Cut across the both sets of 1 inch panels at 1 inch intervals (red lines) see diagram.   See tip at the bottom for cutting with scissors. Burnish & fold the score lines. Fold for either centre to front (male card) or to the back (female card). Play about with it till you like what you see.   I have added a couple of close up photos which I hope show how this one works.   Mat with patterned papers 1 ¼   x 4 ¾   for the side panels and 2 ¾   x 4 ¾ for the centre one.   Cut ten ¾ inch squares,   6 in one pattern 4 in another.     For the 6 coming from the centre I matted onto slightly larger
Read more

Tealight Christmas Tree.

Image
TEALIGHT CHRISTMAS TREE I used the top section template from a previous Christmas tree project ( cutting off the smallest tabs at the bottom of each panel)     to make this small tree measuring about 13cm including base.   Each triangle measures 10.5cm high and 8.5cm wide at the base, with a 2cm tab added to the bottom. Mat and layer with patterned paper.  Die cut lots of stars into each triangle for the light to come through.  Assemble and decorate.  Check that the side tab is not showing through the stars before sticking.   I have u sed FE All That Glistens papers with Simply Creative letter tiles & twine.  The top flower comes from the Festive Wonder collection.    Add a small strip of paper and a bow to the tealight.  
Read more